Skip to content
New consumer mains on a Killara Federation home
Level 2 electrical

Consumer Mains Upgrade North Shore

Old mains between the bracket and the meter board replaced, sized for heat pumps and induction, and run discreetly.

Get a free quote

Takes a minute. We'll call you back, usually the same day.

No obligation. Your details stay with us and are never sold or shared.

The North Shore has some of Sydney’s finest older homes: Federation houses in Lindfield, Killara and Gordon, Arts and Crafts bungalows in Roseville and Chatswood, Californian bungalows in Willoughby, and mid-century homes in St Ives and Turramurra. Many still have the consumer mains they were connected with, the cables running from where Ausgrid’s service line meets the house to the meter board. Those mains were sized for a household that cooked on gas, heated with a fireplace and ran a fridge and a few lights.

Why North Shore homes are upgrading

Going all-electric. Owners are replacing gas cooktops, heaters and hot water with induction, reverse cycle heat pumps and heat pump hot water. That shifts a lot of load onto the electricity supply, especially on winter evenings.

EV charging. A home charger draws steady power for hours, usually overnight.

Renovations. New kitchens, bathrooms, pools and extensions all add load.

Age. Mains installed generations ago may have cracked insulation, loose terminations and undersized conductors.

Signs it’s time

  • Lights dim when the oven, heating or dryer starts
  • The meter box is warm or smells hot
  • The cable at the meter box has a cloth-like or cracked outer
  • The main switch or service fuse trips on cold or hot evenings
  • An installer says the supply is too small for a heat pump, induction or EV charger

How we do it

We trace the existing mains from the bracket or raiser to the meter board and check what they carry. Then we size the new mains for all-electric living with headroom for an EV. If the load calls for it, we’ll recommend a three phase power upgrade instead.

On a heritage or character home, the route matters as much as the cable. We look for a path along a side or rear wall, through a roof space or under eaves, keep new conduit off the street facade where possible, and paint it to match where it shows. On the day, we lodge the notification with Ausgrid, isolate the supply, install the new mains, terminate, test and restore power. You get a certificate of compliance.

Brackets and meter boards

The bracket or raiser on many older homes was fixed into soft brick or old timber decades ago. If it needs replacing, we do a point of attachment upgrade at the same time, and place the new fitting as discreetly as the rules allow. If the meter board needs to move, for example out of a front porch, we plan it with you and, where relevant, with your heritage adviser.

Heritage conservation areas

Large parts of Ku-ring-gai, Willoughby and North Sydney are heritage conservation areas, and many homes are individually listed. Work inside the property and on rear and side walls is usually straightforward, but changes visible from the street need more care. We plan routes and fittings with that in mind.

Going underground instead

If the overhead line is also a problem, an overhead to underground conversion replaces both the line and the mains with an underground supply. On many North Shore homes it’s the cleanest result, inside and out.

Lower North Shore

In Crows Nest, Neutral Bay, Cremorne and Cammeray, terraces, semis and blocks of flats have their own challenges: mains running through shared walls, grouped meters and tight access. We plan these carefully with owners and strata managers.

Get a fixed price

Call your level 2 electrician North Shore team for a look and a fixed written price. We upgrade mains in older homes every week, including in level 2 electrician Killara and Lindfield.

Updated

Pricing depends on the length and route of the mains, how discreetly they need to run on a heritage facade, whether the meter board moves, and whether the supply comes via a private pole. We look first and give you a fixed written price.

What good consumer mains upgrade looks like

Close-up of consumer mains upgrade on a home in the North Shore area
What consumer mains upgrade looks like up close on a typical North Shore area home.
Signs that consumer mains upgrade needs attention
Typical signs that it needs attention.

Consumer Mains Upgrade questions on the North Shore

Something else on your mind? Call 02 9158 9919 and ask.

Our Federation house still has very old cable at the meter box. Is it dangerous?

Old rubber-insulated cable becomes brittle and can crack, exposing conductors. It should be checked and, in most cases, replaced.

We're getting rid of gas. Will the mains cope with heat pumps and induction?

On many older homes, no. Going all-electric adds a lot of load, especially in winter. We size new mains for it, or recommend three phase.

Can the new conduit be painted to match?

Yes. We run it as discreetly as possible and it can be painted to match the wall.

Consumer Mains Upgrade on the North Shore: step by step

  1. InspectWe trace the existing mains, check their size and insulation, and look at how they're fixed to the house.
  2. Plan a discreet routeWe size the new mains for all-electric living and plan a route that respects the facade.
  3. ReplaceAusgrid notified, supply isolated, new mains installed and terminated.
  4. CertifyTested, reconnected and certified the same day.

Need a Level 2 electrician on the North Shore?

📞 Call now Free quote